Common faults and troubleshooting of tissue machine

      Every tissue factory, especially the new tissue factory will encounter such and such problems. If these problems are not handled in time and in place, it will increase our scrap rate! The following introduces the common faults and troubleshooting methods of tissue machine:

1, When the speed of the tissue machine reaches a certain speed point (that is, the point pointed by the motor speed pointer on the tachometer), the paper in the back paper reel will fall off, and then the paper will roll on the wool stick, or it may directly run to the top of the paper breaking knife, and then it will be folded directly without the paper breaking knife. This problem is difficult to find on the front console, and it has already occurred when it is found There are a lot of waste products, so we should inspect the situation behind the machine in time.

Treatment method:

1. If there is no oil on the oilcloth, please apply salad oil or white mineral oil on the oilcloth of face knife and bottom knife;

2. If the air suction is not enough, whether the air suction motor works normally. If not, please replace or repair the motor;

3. The suction pipe is blocked and the ventilation is not smooth. Open the pipe connection and remove the paper scraps on the filter screen.

    There is a rotten paper towel every certain distance, or even every few, which is not synchronized before and after the paper feeding; the processing method is to speed up the paper tray synchronizer at the back two times to see if the problem has been solved. If not, adjust the paper tray synchronizer at the front two times! This will generally solve the problem.

    The paper towel can't be folded and is in a mess. Most of this is due to the shift of the fork. Correcting the position of the fork can solve most of the problems.

     The above points are the most common problems of tissue machine.If you have any problem of tissue machine,please contact Foshan meijing machinery company.